dirna Bergstrom Bycool Green Série Instructions De Montage page 26

DINAMIC 1.1
EN
CONDENSER ASSEMBLY:
Important: Depending on the vehicle, we can position
the pipe outputs on the right or left side.
Note: When the installation is carried out
1
by just one person, mark the bores with the
indicated measurements, taking into account
the pipe length (from the evaporator to the
condenser).
Dismantle cover and release the condenser fan
2
wiring.
If this is carried out by 2 people, introduce
3
the capacitor base, placing it at the most
appropriate part of the rear of the cabin,
taking into account the pipe length from
the evaporator to the condenser, and secure
with at least 6 bores.
First make the (2) upper bores (X) at Ø 9,
4
position M6 rivet nuts and position the base
with screws 6/100x30, mark and make the rest
of the bores (Y), position the nuts.
4
X
Y
Left pipe output
26
Air conditioning for vehicles
ALWAYS
Right pipe output
491
3