Bier Maxx BCT0538 Mode D'emploi page 47

Problem
Is the switch in the 0 posi-
tion?
Was the beer cooled for
The beer is long enough?
too warm.
Are the ventilation slots cov-
ered or is there a clearance
of at least 10 cm on all sides
around the beer pump?
Is the pressure set too low?
Has the beer's best-before
date passed?
The beer
tastes fl at.
Has the beer been tapped
into for too long?
Was the cooling interrupt-
ed?.
Is the CO
The beer fl ows
out of the tap
Is the pressure too low?
too slowly.
Is the beer being squeezed
out of the tap line?
The cooling Was the beer pump set up in
container is a moist environment?
heavily iced
The ambient temperature is
up (Slight icing
too low.
is normal.).
The beer keg
can only be
Was
tapped into
moistened prior to tapping?
with a great
deal of effort.
Possible cause
cartridge empty?
2
the tapping sword
Move the switch to the I position to
switch on the cooling.
Allow the beer to cool for at least 15
hours, ideally 24 hours.
Uncover the ventilation slots and
make sure there is suffi cient clearance
around the beer pump.
Set the pressure higher using the
pressure regulator.
Attach a new beer keg if necessary.
Attach a new beer keg if necessary.
Attach a new beer keg if necessary.
Replace the CO
"Preparation"
Changing the CO
Set the pressure slightly higher using
the pressure regulator.
Open the tap handle completely.
Set the beer pump up in a drier envi-
ronment.
Provide a suffi ciently warm ambient
temperature.
Moisten the tapping sword by holding
it under cold, clear, running water.
47
Remedy
cartridge (see the
2
chapter, "Inserting/
Cartridge" section).
2