Error Codes; Rectifying Some Of The Commonest Faults - DPS-Promatic EVD RS232 DRIVER Manuel D'utilisation

Error codes

Your EVD RS232 DRIVER signals the errors through the discontinuous flashing of a LED.
The flashing LED refers to an error occured on the camera identified by the LED itself.
Number of flashes
4 flashes
3 flashes

Rectifying some of the commonest faults:

Question: I stored the 6 frames correctly, but when I recall them, the camera does not
position correctly.
Reply: The BackUp switch located on the camera head must be set to ON; only in this
way, it is possible to store the settings. For further information about the backup function,
please refer to the camera operation manual.
Question: When pressing the RUN/STOP key to stop the inspection round, this does not
occur immediately.
Reply: Unfortunately, it is necessary to wait that the camera stands still to stop the
inspection round. In any case, the EVD-RS232 controller stores the pressed key and will
stop the inspection round as soon as the camera is stationary. The same applies to the
key F11 (which de-energizes the relay without stopping the alarm related inspection
round).
Error description
No reply of the camera to a command sent
by the DRIVER. Turn off and on again both
camera and EVD RS232 DRIVER.
The camera performs the command, but
signals a positioning error.
Turn off and on again both camera and EVD
RS232 DRIVER.
17