Options And Accessories - Hatco Glo-Ray Série Manuel D'installation Et D'utilisation

English
4" (102 mm) Adjustable Legs (GRSS Model)
Use the following procedure to install 4" (102 mm) adjustable
legs in place of the rubber feet on a GRSS unit.
NOTE: 4" (102 mm) legs are included with models greater than
36" (914 mm) in width.
WARNING
ELECTRIC SHOCK HAZARD: Turn power switch OFF, un-
plug power cord, and allow unit to cool before performing
any maintenance or cleaning.
NOTICE
Do not lay unit on the side with the control panel or dam-
age to unit could occur.
1. Turn off the unit, unplug the power cord, and allow the unit
to cool.
2. Carefully turn the unit upside down and lay the unit on a
flat surface. Make sure to cover the surface with something
to prevent scratching the stone surface.
3. At each corner of the base, remove the foot screw and
rubber foot.
Installing the 4" Legs
4. At each corner of the base, screw a 4" leg into the bottom
of the base.
NOTE: The feet on the 4" legs are adjustable for leveling the unit.
Use a 5/8" (16 mm) open-end wrench to make leveling
adjustments once the unit is placed in its final position.
Handles (GRSS Models only)
Designer black powdercoated rounded stainless steel handles
are available for GRSS models.
The handles are field retrofittable and are installed onto each
end of the unit using the following procedure.
On each end of the unit:
1. Remove the three nuts and washers located on the
underside of the stone surface support ring.
2. Align the three holes on the handle with the three studs on
the support ring, and position the handle on the studs.
3. Replace the three nuts and washers onto the studs, and
tighten securely.
Form No. GRSSM-1020
4" Leg

OPTIONS AND ACCESSORIES

Handle
Handle Installation
Recessed Top for GRSSB Models
An optional recessed top is available for GRSSB models. Units
with a recessed top allows the heated surface to sit lower than
countertop surface.
13
Support
Ring
Stud
Washer
Nut