Options And Accessories - Hatco Glo-Ray GR3SDH Série Manuel D'installation Et D'utilisation

OPTIONS AND ACCESSORIES

Sneeze Guards
Sneeze guards are available for all models as an added option
at the time of order. Sneeze guards can be installed above
each shelf on the customer side of the unit.
1. Remove protective paper from acrylic surfaces.
2. Secure mounting bracket into position with studs facing to
the front and downward by loosening three screws from
underside of shelf, inserting bracket at slots, and tighten
screws.
3. Position the acrylic sneeze guard onto the warmer with the
mounting holes aligned.
4. Secure the sneeze guard using the acorn nuts provided.
Tighten until snug. Do not over-tighten.
Screw
Mounting
Bracket
Stud
Acorn
Nut
Sneeze Guard Installation
Shelf Sign Holder
A shelf sign holder (sign not included) is available for the top
or middle shelf on the customer side. The shelf sign holder is
available as a factory-installed option only.
4" (102 mm) Adjustable Legs
4" (102 mm) legs are available in lieu of the 2-1/2" (64 mm)
legs for installations that require additional clearance between
the unit and countertop.
Product Divider Rods
Stainless steel product divider rods are available as an
accessory.
3SD-DIV ................ Stainless Steel Divider Rod
Designer Colors
Designer colors are available as an option at the time of order.
Plexiglass Side Panels
Plexiglass side panels are available as a factory installed
option in lieu of glass side panels.
Flip-Up Doors
Flip-up doors are available for all models as an added option at
the time of order. Flip-up doors can be ordered on each shelf
and on either the customer side or operator side of the unit.
NOTE: Door should swing fully up for product placement.
NOTE: When loading/unloading product, use door hook to hold
flip-up door in the open position.
14
English
Form No. GR3SDM-0920