Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
b. Check to see if receptacle is connected to a light
switch which turns power off when you turn out
the lights;
c. Move the charger and battery pack to a location
where the surrounding air temperature is
approximately 65 °F – 75 °F (18 ° – 24 °C);
d. If charging problems persist, take the tool, battery
pack and charger to your local service center.
4. The battery pack should be recharged when it fails to
produce sufficient power on jobs which were easily
done previously. DO NOT CONTINUE to use under these
conditions. Follow the charging procedure. You may also
charge a partially used pack whenever you desire with
no adverse effect on the battery pack.
5. Foreign materials of a conductive nature such as, but
not limited to, grinding dust, metal chips, steel wool,
aluminum foil, or any buildup of metallic particles
should be kept away from charger cavities. Always
unplug the charger from the power supply when there
is no battery pack in the cavity. Unplug the charger
before attempting to clean.
6. Do not freeze or immerse the charger in water or any
other liquid.
Storage Recommendations
1. The best storage place is one that is cool and dry, away
from direct sunlight and excess heat or cold.
2. For long storage, it is recommended to store a fully
charged battery pack in a cool dry place out of the
charger for optimal results.
nOTE: Battery packs should not be stored completely
depleted of charge. The battery pack will need to be
recharged before use.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
Intended Use
This string trimmer is designed for professional trimming
applications. This product is not an edger and is not
intended to be used for edging.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
This string trimmer is a professional appliance. DO nOT
let children come into contact with the tool. Supervision is
required when inexperienced operators use this tool.
ASSEMBLY (FIG. A, D, E)
Assembling the Pole
1. To assemble the pole, line up the upper trimmer pole
and the lower trimmer pole
down the latching button
into the lower pole. Ensure the latching button engages
the latch hole
14
.
2. Secure the poles by tightening the middle bolt
the supplied hex wrench
5
6
as shown in Fig. A. Press
15
and slide the upper pole
16
with
17
as shown in Fig. E.
Fig. D
14
Fig. E
Attaching Guard (Fig. F, G)
WARNING:
Damage or personal injury could result.
WARNING:
APPLIANCE WITHOUT GUARD FIRMLY IN PLACE.
The guard must always be properly attached on the
appliance to protect the user.
1. Assemble the guard
8
to the motor housing
2. Using a cross head screwdriver, insert the 2 guard
screws
18
and tighten securely.
nOTE: An extended coverage guard is available (sold
separately) for extra coverage if desired. Use replacement
guard Part Number N688823.
Fig. F
4
Fig. G
18
English
15
16
17
Never remove the guard.
NEVER OPERATE
4
.
8
7
Publicité
Table des Matières
