Replacement Accessories - DeWalt DCST925 Guide D'utilisation

Taille-bordure au lithium 20 v max
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles


WARNING:
personal injury, ALWAYS hold securely in anticipation
of a sudden reaction.
Proper hand position requires one hand on the primary
handle 
 3 
and one hand on the auxiliary handle 
Fig. L
3
Switching Trimmer On and Off (Fig. A)
To turn the appliance on, squeeze the lock-off lever 
then the variable speed trigger 
release the variable speed trigger and the lock-off lever.

WARNING:
trigger in the on position.
Trimming (Fig. M, N)
With the trimmer on, angle it and swing side to side as
shown in Fig. M.
Maintain a minimum distance of 24" (610 mm) between the
guard and your feet as shown in Fig. N.
Fig. M
Fig. N
Minimum
24" (610 mm)

WARNING:
roughly parallel with the ground (tilted no more than
30 degrees). This trimmer is not an edger. DO NOT
TILT the trimmer so that the string is spinning near
To reduce the risk of serious
 13 
.
13
 2 
and
 1 
. To turn the appliance off,
Never attempt to lock the
Keep the rotating string
a right angle to the ground. Flying debris can cause
serious injury.
Bump Feed Trimmer Line Feed
Your trimmer uses 0.080" (2.0 mm) diameter nylon line.
Cutting line will wear faster and require more feeding if the
cutting is done along sidewalks or other abrasive surfaces or
heavier weeds are being cut.
As you use the trimmer, the string will get shorter due
to wear. Gently bump the trimmer on the ground while
running at normal speed and the line will feed.
nOTE: Extending nylon line beyond the 13" (330 mm)
swath will negatively affect performance, runtime, and the
life of the trimmer due to potential of damaging motor.
Doing so may void the warranty.
Helpful Cutting Tips
Use the tip of the string to do the cutting; do not force
string head into uncut grass.
Wire and picket fences cause extra string wear, even
breakage. Stone and brick walls, curbs, and wood may
wear string rapidly.
Do not allow spool cap to drag on ground or
other surfaces.
In long growth, cut from the top down and do not
exceed 12" (304.8 mm) high.
Keep trimmer tilted toward the area being cut; this is
the best cutting area.
The trimmer cuts when passing the unit from the left to
right. This will avoid throwing debris at the operator.
Avoid trees and shrubs. Tree bark, wood moldings,
siding, and fence posts can easily be damaged by
the string.

Replacement Accessories


WARNING:
of serious personal injury, turn appliance
off and remove battery before making any
adjustments or removing/installing attachments
or accessories.

WARNING:
recommended by D
WALT for use with this appliance
e
could be hazardous.

WARNING:
or any accessory or attachment other than those
recommended by D
WALT on this trimmer. Serious
e
injury or product damage may result.
Use D
WALT replacement line Model No. DWO1DT801
e
or DWO1DT802.
When replacing the line, use only 0.080" (2.0 mm)
diameter line (Model No. DWO1DT801 or DWO1DT802 are
recommended). Other sizes may degrade performance or
cause damage to the trimmer.
English
To reduce the risk
The use of any accessory not
Do not use any blades,
9

Publicité

Table des Matières
loading

Table des Matières