Sony SCPH-10171 Mode D'emploi page 52

Using the Control Panel (continued)
• Dolby Digital
Selects the Dolby Digital signal that is output when you connect to the console
with an optical digital cable (sold separately).
– On : Select this option when you have an audio component with a built-in
Dolby Digital decoder connected to the console.
If the console is connected to an audio component without a built-in
Dolby Digital decoder, do not turn this option on. If you select this
option by mistake, when you play a Dolby Digital audio track, a loud
noise (or no sound) will come out from the speakers, possibly hurting your
ears or damaging the speakers.
– Off : Select this option when you have an audio component without a built-in
Dolby Digital decoder connected to the console.
• DTS
Selects the DTS signal that is output when you connect to the console with an
optical digital cable.
– On : Select this option when you have an audio component with a built-in
DTS decoder connected to the console.
If the console is connected to an audio component without a built-in
DTS decoder, do not turn this option on. If you select this option by
mistake, when you play a DTS audio track, a loud noise (or no sound) will
come out from the speakers, possibly hurting your ears or damaging the
speakers.
– Off : Select this option when you have an audio component without a built-in
DTS decoder connected to the console.
x Audio Track Auto Select Mode
Gives priority to the audio track with the highest number of channels when
you play a DVD on which multiple audio formats (PCM, Dolby Digital, or
DTS) are recorded.
• On : Priority given.
• Off : No priority given.
52