Two-Step Crimping - GLW EC 65 Mode D'emploi

Two-step crimping

1. Set mode 2
 Switch on the EC 65 at the power switch (1)
(press I).

lights up (2).

Set mode 2 (3).
 Read counter (4) if necessary and
reset to 0 with
2. Clamp crimp contact
Centre the crimp contact (1) on the bottom die.
Pay attention to correct cross section
!
according to the company
supplementary sheet.
Press the foot switch (2) until the crimp contact is
clamped (3).
Release the foot switch (4).
12/09
OPERATION
(5).
Figure 13 Set mode 2
Figure 14 Clamp crimp contact
EC 65
15