Ryobi LTS180 Manuel D'utilisation page 7

EN
FR DE ES IT NL
NOTE: For dry cutting, leave water bottle installed to
prevent dust and debris from clogging the water supply
system.
CAUTION
Water bottle is designed for water only. Use of
any other fluid may cause damage to the tool.
WARNING
A 101.6 mm wheel is the maximum wheel capacity
of the saw. Also, never use a wheel that is too
thick to allow outer wheel washer to engage with
the flat on the spindle. Larger wheels will come
in contact with the wheel guards, while thicker
wheels will prevent wheel screw from securing
wheel on spindle. Either of these situations could
result in a serious accident.
WARNING
Do not use cutting wheels rated less than the
no load speed of this tool. Failure to heed this
warning could result in personal injury. Do not
use wheel with cracks, gaps, or teeth.
WARNING
Do not use toothed or segmented wheels. Use
only continuous rimmed diamond wheels suited
for masonry materials.
INSTALLING CUTTING WHEEL
See Figure 3
Remove the battery pack from the saw.
Remove the wheel wrench (5 mm hex key) from the
storage area.
Depress the spindle lock button and remove the wheel
screw and outer wheel washer.
NOTE: Turn the wheel screw clockwise to remove.
CAUTION
To prevent damage to the spindle or spindle lock,
always allow motor to come to a complete stop
before engaging spindle lock.
NOTE: Do not run the saw with spindle lock engaged.
Wipe a drop of oil onto the inner wheel washer and
outer wheel washer where they contact the wheel.
WARNING
If inner wheel washer has been removed, replace
it before placing cutting wheel on spindle. Failure
to do so could cause an accident since wheel will
not tighten properly.
Replace the outer wheel washer.
PT DA SV FI NO RU
English
PL CS HU RO LV LT
Depress the spindle lock button, then replace the
wheel screw. Tighten the wheel screw securely by
turning it counterclockwise.
Return the wheel wrench to the storage area.
NOTE: Never use a cutting wheel that is too thick to allow
the outer wheel washer to engage with the flats on the
spindle.
OPERATION
WARNING
Always wear a dust mask when operating tile
saws. Failure to do so could result in serious
injury.
WARNING
Always wear safety goggles or safety glasses with
side shields when operating products. Failure to
do so could result in objects being thrown into
your eyes, resulting in possible serious injury.
WARNING
Do not use any attachments or accessories
not recommended by the manufacturer of this
product. The use of attachments or accessories
not recommended can result in serious personal
injury.
BATTERY PROTECTION FEATURES
RYOBI 18 V lithium-ion batteries are designed with
features that protect the lithium-ion cells and maximize
battery life. Under some operating conditions, these
built-in features may cause the battery and the tool it is
powering to act differently from nickel-cadmium batteries.
During some applications, the battery electronics may
signal the battery to shut down, and cause the tool to stop
running. To reset the battery and tool, release the trigger
and resume normal operation.
NOTE: To prevent further shut down of the battery, avoid
forcing the tool.
If releasing the trigger does not reset the battery and tool,
the battery pack is depleted. If depleted, the battery pack
will begin charging when placed on the lithium-ion charger.
INSTALLING THE BATTERY PACK
See Figure 4.
Place the battery pack in the saw. Align the raised rib
on the battery pack with the groove inside the saw,
then slide the battery pack into the saw.
Make sure the latches on each side of your battery
pack snap into place and the battery pack is secured
in the saw before beginning operation.
3
ET HR SL SK BG UK TR EL