Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Making sure the mounting positions
of the display
Be careful not to pinch your fingers or scratch the
center cluster panel of your car when attaching the
display to the unit.
1
Attach the display to the unit temporarily.
2
Confirm that the display does not block the
driver's view or interfere with normal
driving operations.
If further adjustment of the mounting position
(depth, height, angle) is necessary, remove the
display from the unit, then adjust it again
accordingly.
Organizing the USB cable
1
Connect the USB extension cable (short)
to the USB port of the display, then route
the cable along the groove.
To prevent the extension cable from coming off,
be sure to route the USB cable along the groove
through the catches inside.
18
GB
Attaching the display to the unit
Be careful not to pinch your fingers or scratch the
center cluster panel of your car when attaching the
display to the unit.
1
Attach the display to the unit.
Make sure that the connector brackets of the
display is fully inserted to the unit.
2
Tighten 4 screws (on top) to secure the
connector bracket to the unit.
Tighten the screws firmly.
When you tighten a screw, be careful not to
apply too much torque as doing so may damage
the screw (the torque value should be from
1.2 N•m to 1.5 N•m).
3
Slide the joint cover out to protect the
mounting base of the display, then tighten
the fixing screw to secure the cover.
Tighten the screw firmly.
When you tighten a screw, be careful not to
apply too much torque as doing so may damage
the screw (the torque value should be from
1.2 N•m to 1.5 N•m).
Publicité
Table des Matières
