Resetting The Microprocessor; Preparing The Remote Control; Setup Menu - Pioneer MVH-S300BT Mode D'emploi

Masquer les pouces Voir aussi pour MVH-S300BT:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Resetting the microprocessor

The microprocessor must be reset in the following situations:
– Before using this unit for the first time after installation
– If the unit fails to operate properly
– When strange or incorrect messages appear on the display
1
Remove the front panel (page 5).
2
Press the RESET button with a pointed instrument longer than 8 mm.

Preparing the remote control

Remove the insulation sheet before use.
How to replace the battery
Insert the CR2025 (3 V) battery with the plus (+) and
minus (–) poles orientated properly.
6
En
RESET button
WARNING
• Do not ingest the battery, Chemical Burn Hazard.
(The remote control supplied with) This product contains a coin/button cell battery. If the
coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and
can lead to death.
Keep new and used batteries away from children.
If the battery compartment does not close securely, stop using the product and keep it
away from children.
If you think batteries might have been swallowed or placed inside any part of the body,
seek immediate medical attention.
• Do not expose the battery or remote control to excessive heat such as direct sunlight or
fire.
CAUTION
• There is a potential danger of explosion if the battery is incorrectly replaced. When
replacing the battery, replace it with the same type.
• Do not handle or store the battery with metallic tools or objects.
• If the battery leaks, remove the battery and wipe the remote control completely clean.
Then install a new battery.
• When disposing of used batteries, please comply with governmental regulations or
environmental public institutions' rules that apply in your country/area.
• "Perchlorate Material - special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate. (Applicable to California, U.S.A.)"
Important
• Do not store the remote control in high temperatures or direct sunlight.
• Do not let the remote control fall onto the floor, where it may become jammed under the
brake or accelerator pedal.

Setup menu

When you turn the ignition switch to ON after installation, the setup menu
appears in the display.
1
Turn the M.C. dial to select the options, then press to confirm.
To proceed to the next menu option, you need to confirm your selection.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Mvh-s301bt

Table des Matières