System Setting; Parental Lock - Zodiac DZR-3000FTA Manuel D'utilisation

4.5 System Setting

The System Setting menu allows you to set items depending on your environment.
1. OSD Language: Lets you select the desired language.
2. Audio Language: Select the desired audio language to be in top priority under the condition that this
language is supported by the channel.
3. LNB power: If your DZR is connected to the LNB, select YES. But if your DZR is connected to another
receiver through Loop Through support, you should check which receiver is connected directly to the LNB.
In case the other receiver is directly connected to the LNB, then select OFF.
4. Screen Format: If your TV supports 16:9 screen format and selected channel provides 16:9 format
program, select 16:9.
5. Video output: If your SCART supports RGB control, select RGB. Otherwise select CVBS.
6. TV type: Select hte Type according to your TV type.
7. Display Info Bar: You can adjust the displaying time interval for the info bar from 2 sec to 12 sec. Default
value is 6 sec.
8. Start On Channel: If you press OK key, then the channel list is displayed. You can select one channel from
the list. The selected channel starts whenever you turn on DZR.
9. UHF Standard: Select UHF type.
10. UHF Channel: Select your desired UHF channel for satellite mode.
Note: In countries where UHF is not used, options in List 9 and 10 will be deleted.

4.6 Parental Lock

This function allows you to lock the channel with a password in order to prevent children from accessing the
channel.
You can also protect your installed data and information using the Install Lock.
How to change the password
1. Enter the current password.
2. Select ON of Parental Lock.
3. Enter new password.
4. Confirm your new password entering new password.
Note: Default password is 0000.
Warning: Once you change the password, please keep it safely.
How to use Parental Lock
1. To activate parent lock function, go to the TV channel Manager Page.
2. Press Lock key (Blue color key) on the RCU.
3. Select the channel which you want to Lock.
4. Press OK then symbol is displayed.
How to use Install Lock
1. Enter the current password.
2. Select ON of Install Lock.
3. Enter new password.
4. Confirm your new password entering new password again.
5. Exit this menu.
6. Select any menu and press OK on the RCU.
7. Then the Enter Password box will be displayed.
8. Unless you enter the correct password, you can not run any menu.
NOTE: Default password is 0000.
WARNING: Do not forget your password.
E - 6
ENGLISH