Connecting The Power Cord; Attaching The Ferrite Core - Pioneer PDP-5080XD Mode D'emploi

Preparation
Attaching and removing speed clamps
Insert [1] into an appropriate hole on the rear of the plasma
television and snap [2] into the back of [1] to lock the clamp.
1
• Speed clamps are designed to be difficult to undo once in place.
Please attach them carefully.
• Use pliers to twist the clamp 90º, pulling outward. The clamp
may deteriorate over time and become damaged if removed.
• Be careful not to subject any connecting cables to strain.
Note
• Use the speed clamps as necessary.

Attaching the ferrite core

Attach the accessory ferrite core to the end of the power cord as
shown in the accompanying illustration. Use the provided cable tie
to prevent the ferrite core from slipping on the table.
If you do not do this, the plasma television will not conform to
mandatory CE standards.
1
2
To power outlet
AC power cord
2
4
3
Ferrite core
Cable tie
As close as possible

Connecting the power cord

Rear view
Power cord
Note
• Disconnect the power cord from the power outlet when the
plasma television is not going to be used for a long period of
time.
• Insert the power plug in the AC outlet, after all other
components are connected.
05
Europe, except UK and
Republic of Ireland
UK and Republic of Ireland
19
En