Preparation; Installing The Plasma Television; Moving The Plasma Television - Pioneer PDP-5080XD Mode D'emploi

Preparation

Chapter 5
Preparation

Installing the plasma television

Over
10 cm
Location
• Avoid direct sunlight. Maintain adequate ventilation.
Caution
• If you do not leave sufficient space above the plasma television,
it will not receive enough ventilation and will not operate
properly.
• Pioneer will not be responsible for accident or damage caused
by inadequate installation or stabilization, erroneous operation,
remodeling or natural disasters.
Note
• Allow enough space around the upper and back parts when
installing to ensure adequate ventilation of the rear of the unit.
• Be sure to install the plasma television in a flat, stable location.
Using the optional Pioneer stand
(for PDP-5080XD/PDP-SX5080D only)
For details on installation, refer to the instruction manual supplied
with the stand.
Using the optional Pioneer speakers
(for PDP-5080XD/PDP-SX5080D only)
For details on installation, refer to the instruction manual supplied
with the speakers.
Over 50 cm

Moving the plasma television

When installing on a rack, etc., hold the plasma television as shown
below. Because the plasma television is heavy, be sure to have
someone help you when moving it.
(for PDP-5080XD/PDP-SX5080D)
Note
• Do not use the speaker to support the weight of the plasma
television.
• Always remove the speakers before moving the plasma
television. Do not hold the plasma television by the speaker
mounting fittings.
(for PDP-4280XD/PDP-SX4280D)
05
15
En