Preventing The Plasma Television From Falling Over - Pioneer PDP-5080XD Mode D'emploi

05 Preparation
Preventing the plasma television from
falling over
After installing the stand, be sure to take special care to ensure that
the plasma television will not fall over and is stabilized to both the
wall and rack.
Stabilizing on a table or rack
For PDP-5080XD/PDP-SX5080D:
Stabilize the plasma television as shown in the diagram using the
plastic bands and screws supplied with the optional stand.
For PDP-4280XD/PDP-SX4280D:
Stabilize the plasma television as shown in the diagram using the
supplied plastic bands and screws.
Note
• To stabilize the plasma television on a table or rack, also use
commercially available wood screws that have a nominal
diameter of 4 mm and that are at least 20 mm long.
20 mm min.
Screw
Wood screw
(M4 x 10 mm)
(commercially available,
4 mm x 20 mm min.)
Drill a hole in the middle at the rear of the tabletop panel before
using a wood screw. Perform this work the same way on the left and
right sides.
16
En
Screw Screw Screw
Wood screw
Using a wall for stabilization
1 Attach falling prevention bolts (hooks) to the plasma
television.
2 Use strong cords to stabilize it appropriately and firmly to a
wall, pillar, or other sturdy element.
Perform this work in the same way on the left and right sides.
Use hooks, cords and fittings that are available on the market.
Recommended hook: Nominal diameter 8 mm, length 12 mm to
18 mm
1. Hook
2. Cord
Fitting
Caution
• A table or rack with adequate strength should always be used to
support the plasma television. Failure to do so could result in
personal injury and physical damage.
• When installing the plasma television, please take the
necessary safety measures to prevent it from falling or
overturning in case of emergencies, such as earthquakes, or of
accidents.
• If you do not take these precautions, the plasma television could
fall down and cause injury.
• The screws, hooks, cords and other fittings that you use to
secure the plasma television to prevent it from overturning will
vary according to the composition and thickness of the surface
to which it will be attached.
• Select the appropriate screws, hooks, cords, and other fittings
after first inspecting the surface carefully to determine its
thickness and composition and after consulting a professional
installer if necessary.
12 mm to 18 mm