Controls - Elica ETP536SS Guide D'utilisation, D'entretien Et D'installation

Controls

Use the high suction speed in cases of
concentrated kitchen
recommended that the cooker hood suction
is switched on for 5 minutes prior to cooking
and to leave in operation during cooking and
for another 15 minutes approximately after
terminating cooking.
Description of control panel
The hood is equipped with a "TOUCH"
device to control the lights and speed.
For the correct use please carefully read the
intructions below.
Automatic start-up function
The hood is equipped with a temperature
sensor which activates the motor to the first
suction speed (power) in the event that the
room temperature in the surrounding area is
higher than 70°C.
The user may switch off or modify the suction
speed (power) (see paragraph "suction
speed (power) control").
Suction speed (power) control
The suction speed (power) is cyclical
depending on the speed sequence "stand-by
– 1-2-3-4- Stand by -1-2-..." therefore every
time the T1 button is pressed on the control
panel, the suction speed (power) is increased
by one level, in order to switch off (stand-by)
if the button is pressed again when the hood
is in suction speed (power) 4.
The hood may be switched off (stand-by)
while the hood is set on any speed by
vapours. It is
holding down the T1 button on the control
panel for a bit longer (more than 3 seconds).
The hood's suction speed (power) may be
determined as the control panel is equipped
with a LED light that changes colors as
follows, depending on the suction speed
(power):
Hood in stand-by: LED LIGHT SWITCHED
OFF
1 st suction speed (power) -GREEN LED
LIGHT
2 nd
suction speed (power) – ORANGE
LED LIGHT (amber)
3 rd
suction speed (power) - RED LED
LIGHT
4 th
suction speed (power) - RED LED
LIGHT (FLASHING)
Note: The 4 th suction speed (power) stays
on for 5 minutes, after which the suction
motor will position itself on the 2 nd speed.
If pressed again, the suction motor will switch
off (stand-by).
Grease filters need cleaning: FLASHING
GREEN LED light (read instructions found
under "Reset and configuration for filter
saturation signal")
Coal filters must be cleaned or replaced:
FLASHING ORANGE (amber) LED light
(read instructions found under "Reset and
configuration for filter saturation signal")
Note: The reset procedure may be activated
by both the control panel and the remote
control.
Center light check
The center light may be switched on and off
by pressing the T2 button on the control
panel.
Side light check (when scheduled)
The side lights may be switched on and off
by pressing AND HOLDING DOWN the T2
button on the control panel.
17