Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
(1) If operated in dusty areas carry out maintenance more frequently.
(2) A specialist technician should carry out this maintenance if the owner does not have the
appropriate tools or mechanical knowledge.
Air filter (Fig.H-1)
1.
Loosen the air filter cover screw and remove the air filter cover.
2.
Wash the air filter in solvent.
3.
Thoroughly squeeze the filter removing excess oil.
4.
Reinstall the air filters.
5.
Reinstall the air filter cover, and tighten the air filter cover screw.
WARNING:
The use of petrol or combustible solvents for cleaning can cause fire or explosion.
Therefore only use soap water or non-combustible solvent. Never operate the machine
without the air filter
Spark plug(Fig.H-2)
To ensure proper engine operation, the spark plug must be properly gapped and free of deposits.
1.
Remove the spark plug cover from the housing.
2.
Remove the spark plug cap.
3.
Clean any dirt from around the spark plug base.
4.
Use the socket spanner which provided to remove the spark plug.
5.
Visually inspect the spark plug. Remove carbon deposits using a wire brush.
6.
Check for discoloration on the top of the spark plug. The standard color should be a tan
color.
7.
Check the spark plug gap. The acceptable gap should be between 0,6-0,7mm.
8.
Install /reinstall the spark plug carefully by hand.
9.
Once the spark plug has been seated, tighten it with a socket spanner.
10. Reinstall the spark plug cap on top of the spark plug.
11. Reinstall the spark plug cover.
Cleaning
1.
Keep your machine clean, the outside of the machine can be cleaned using a damp
soft cloth with a mild detergent if required, never use water to clean the machine as it
may cause damage to internal parts.
2.
Some maintenance products and solvents may damage the plastic parts, these include
products containing benzene, trichloroethylene, chloride or ammonia.
3.
Take special care to keep the ventilation inlets /outlets free from obstruction. Cleaning with
a soft brush followed by a compressed air jet will usually be sufficient to ensure
acceptable internal cleanliness.
4.
Wear eye protection when carrying out cleaning.
Empty the fuel
1.
Place the machine on even and stable surface. Warm up the engine for several minutes
and then stop it.
.
31
Publicité
Table des Matières
