Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Make sure the handle and safety features are in good working order. Never use a machine that
lacks a part or has been modified outside its specifications.
The enclosures must be correctly fitted and undamaged before you start the machine.
WARNING!
Please always use quality gloves, foot, ear and eye protector. They should with CE mark and
tested according to PPE (Person Protective Equipment) directive.
Poor equipments may reduce the protection and result in person injure during working.
Engine fuel
WARNING!
The grass trimmer is fitted with a two-stroke engine; use fuel mixed with oil only.
WARNING.
● Do not refill fuel while engine is running or hot.
● Make sure fuel is not leaking.
Use quality two-stroke oil and make a mixture of 40 parts petrol(unlead, octan> 90) to one
part oil (special oil for 2 stroke engines)only (2,5% oil mixed in fuel).
Never use two-stroke oil intended for water-cooled engines. Never use oil intended for four-
stroke engines.
A poor oil quality and/or too high oil/fuel ratio may jeopardize function and decrease the life time
of catalytic converters.
Shake the container well to obtain a correct mixture before filling the tank.
Use at least 90 octane fuel. We recommend unleaded petrol as it leaves fewer residues inside
the motor and on the ignition plug, and prolongs the life cycle of the exhaust system. Never use
old or dirty petrol or oil/petrol mixtures. Avoid contamination with dirt or water in the tank.
Occasionally ignition knocking or clanging can be heard with high loads. This is normal and no
cause for alarm. If ignition knocking or clanging occurs during normal loads and with constant
motor speed you should change the petrol quality. If this does not solve the problem contact an
authorized specialist dealer.
When working at continuous high revs a higher octane rating is recommended.
Only fuel the machine in well-lit areas. Avoid fuel spillage. Never refuel the machine during
operation. Let the engine cool down for about two minutes before refueling.
Refueling must not be carried out near naked flames, control lamps or spark producing
electrical equipment such as electric tools, welders or sanders.
1.
Make sure the machine is turned off, by turn the engine switch to the "off" position.
26
Publicité
Table des Matières
