Lea LE24250DP Mode D'emploi page 29

This unit is designed to be used in accordance with the descriptions and safety instructions
indicated in this operating manual.
for private use;
-
for trimming lawn edges and small inaccessible areas of grass(e.g. under bushes);
-
for cutting wild growth, shrubs and undergrowth.
-
It is not permitted to use this unit for any other purposes.
The user is liable for all injuries to third parties and damage to their property.
Operate the unit only in the technical condition as stipulated and delivered by the manufacturer.
Arbitrary changes to the unit will exclude the manufacturer from any liability for resulting injury
and/or damage.
ASSEMBLY
WARNING! Please ensure that the grass trimmer is switched off properly and that
the engine has stopped completely before assembly and adjustment.
Assembly of t h e h a n d l e (Fig.B-1,B-2,B-3)
1. Remove the screws from the handle
2. Place the handle in position and assembly the front cover.
3. Assembly and tighten the screw.
CAUTION!
Do not tighten the screws until you have set the handle in optimal working position.
Please always adjust the handle position with full assembled accessories.
Assembly the guard (Fig.C-1, Fig.C-2)
1. Loosen the screw on the fixed guard with the 5mm Allen key
2. Place the guard on the fixture.
3. Assembly and tighten the screws.
Divisible shaft assembly (Fig.D-1,Fig.D-2)
1. Loosen the wing nut on top of the shaft (Fig. D-1).
2. Slide the bottom part of the shaft into the grip the top.
3. The holding pin on the bottom part must visibly engage (Fig.D-2).
4. Tighten the wing nut.
WARNING! Before starting the machine, ensure that both shaft parts fit tightly together and
wing nut is sufficiently tightened.
OPERATION
Before use
Please always read the instruction manual carefully and check the machine before operating.
WARNING!
The grass trimmer is fitted with a two-stroke engine, so no need fill oil separately. Fill
the oil mixed with fuel, please consult below section.
25