RIDGID R4041 Manuel D'utilisation page 28

ADJUSTMENTS
POSITIVE STOP ADJUSTMENTS
See Figure 44.
NOTE: These adjustments were made at the factory and
normally do not require readjustment.
 Unplug the saw.
If the wheel is not perfectly vertical (0°):
 Loosen the bevel lock knob.
 Raise the motor head.
 Place a combination square beside the wheel.
 Using a wrench, turn the 0° hex bolt until the wheel is
square to the table and the hex bolt is resting on the saw
housing.
 Tighten the bevel lock knob.
If the wheel is not an exact 45°:
 Set bevel to 45°.
 Place a combination square against the wheel and set
the motor head at 45°.
 Using a wrench, turn the 45° hex bolt until the hex bolt
is resting on the saw housing.
ALIGNING THE LASER GUIDE LINE
See Figure 45.
DANGER:
Laser radiation. Avoid direct eye contact with light
source.
WARNING:
Use of controls or adjustments or performance of
procedures other than those specified herein can
result in hazardous radiation exposure.
 Use a work clamp or a C-clamp to secure a piece of scrap
tile.
 Draw a line on the tile.
 Plug the saw into the power source and make a slight cut
to score the tile.
 Release the switch trigger and allow the saw blade to
stop rotating before raising the wheel.
 Roll sliding table away from cutting wheel. Lower and
lock motor head.
 Turn on the laser.
 To adjust the laser line, open the cutting wheel guard,
loosen the Phillips head screw, adjust the laser module
as needed, and tighten the screw securely.
 Once aligned, close and lock the wheel guard.
NOTE: Always make practice cuts on scrap material before
cutting through your workpiece.
45° SET
BOLT
28 — English
BEVEL LOCK
KNOB
SCREW
0° SET
BOLT
Fig. 44
Fig. 45