RIDGID R4041 Manuel D'utilisation page 25

OPERATION
 Move the sliding table away from the motor head and
turn paver over to make through cut.
To make paver for corners:
 Measure paver and landscaping feature to determine how
much material needs to be removed and how much of an
angle is required for wall corner.
 Using grease pencil and square, draw a mark from center
of brick to corner, marking all the way around the paver.
 Place the material on the table and firmly against the
fence.
 Make sure the material is clear of the cutting wheel before
turning on the saw.
 Turn the on/off switch to the on position.
 Let the cutting wheel build up to full speed and wait for
the wheel to get wet before moving the material into the
wheel.
 Hold the material firmly against the miter guide and fence
and feed the material into the cutting wheel.
 When the cut is made, turn the saw off. Wait for the cut-
ting wheel to come to a complete stop before removing
any part of the material.
 Move the sliding table away from the motor head and
turn paver over to make through cut.
 If stacking paver, knock off pavers' drop edge, turn paver
over and lay paver.
NON- THROUGH
CUT
Fig. 35
25 — English
MARK
DROP EDGE
REMOVED
THROUGH CUT
Fig. 36
FINISHED PAVER
Fig. 37