Setting The Function Switches - FMS 1086440 Notice D'emploi

Caution, important!
There are six switches at the transmitter (also see figure 20) that should be in the correct positions (factory
setting) when the plane model is delivered.
Adjusting of the switches is usually not required for operation of the plane model „Red Dragonfly".
If you want to perform adjustments, first write down the factory settings.
To be able to adjust the transmitter to other models as well, the switches 1 - 6 (from the left to the right, see figure
20) have the following functions:
• Switch 1: Reverse function channel 1
This switch can be used to switch the aileron servo running direction on demand.
• Switch 2: Reverse function channel 2
This switch can be used to switch the elevator servo running direction on demand.
• Switch 3: Reverse function channel 3
This switch can be used to switch the running direction of the speed control lever on demand.

16. Setting the Function Switches

Figure 20
67