Orbegozo RRE 510 A Mode D'emploi page 40

RRE 510 A 810 A 1010 A 1310A 1510 A 1810 A
With the button + or – we pass through the days until we find the current day, e.g. Monday, we go to
1, or Wednesday, we using button + or – to 3. (Fig.26)
Now we press button M and the hour display starts to flash. With button + or – we adjust the display
to the correct hour, then press button M.
Now the minutes display starts to flash. With button + or – we adjust the display to the correct
minute, then press M. The appliance returns to the OFF position.(Fig.27)
Important:
1. If you want to change the mode at any time, use the - button to go back hour by hour and
press M to change the mode to the desired one.
2. You must schedule 24/7. You can't skip days and leave them unscheduled. If you want to
program a day in which the transmitter is switched off at all times, you must select the
Antifreeze mode at all hours of that day.
3. If you want to exit at any time to set the current day of the week and time, press
mind that the transmitter will work with the last programming carried out on each day. That is,
if you exit the schedule after ending Wednesday (3), the device will work with the schedule you
just did between Monday (1) and Wednesday (3) but from Thursday (4) to Sunday (7) it will
work with the last programming that has been done in those days.
Fig.25
Fig.26
Fig.27
OFF position
. Keep in
40