Installer Settings; Keypad Lock/Unlock; Energy Consumption; Open Window Detection - Vasco Basic Manuel D'utilisation Et D'installation

INSTALLER SETTINGS 1.1

KEYPAD LOCK/UNLOCK

• Keypad lock
To lock the keypad, press the
and hold them down for 10 seconds. The padlock
symbol appears on the display, the keypad is
locked.
• Keypad unlock
To unlock the keypad, press the
hold them down for 10 seconds again. The padlock
symbol disappears from the display, keypad is
unlocked.

ENERGY CONSUMPTION

A selector indicates the energy comsumption level by positioning it in front of the colour: red, orange or green.
C - Red
higher consumption
B - Orange
average consumption
A - Green
lower consumption
• Display of the estimated power consumption in kWh
To see this estimation from Auto, Comfort, Eco or Frost protection mode, then press
consumption: press any button, the device is automatically in the previous active mode.
• Resetting the energy meter
To reset the energy meter from Auto, Comfort, Eco or Frost protection mode, then proceed as follows.
1- Press .
2- Press simultaneously
5 seconds.
To exit resetting the energy meter, press any button,
the device is automatically in the previous active mode.

OPEN WINDOW DETECTION

The open window detection is sensitive to temperature fluctuations. The controller responds to open windows according
to various parameters: temperature setting, rise and fall of the room temperature, outside temperature, location of the
radiator, etc. If the controller is close to a front door, the detection air can be disturbed opening the door. If this is a
problem, we recommend you disable the open window detection (see installer settings).
When the controller proceeds to a temperature reduction cycle (frost protection mode) by opening a window, a frost
protection counter appears on the display to show the cycle duration. The counter is automatically reset to zero the
next time the Frost Protection is switched on. By pressing a button, the frost protection mode is deactivated.
Note: if a temperature rise is detected, the controller will automatically return to the previous mode.
12
and buttons
and buttons
Setting temperature
> 22°C
Setting temperature
>19°C ≤ 22°C
Setting temperature
≤ 19°C
and for more than
3
10 sec.
1 2 3 4 5 6 7
10 sec.
24 . 0 c
O
21 . 5 c
O
19 . 0 c
O
. To exit the display mode of
0000
1 2 3 4 5 6 7