Technical Data - Bosch GST 120 E Professional Notice Originale

OBJ_BUCH-655-004.book Page 9 Wednesday, July 1, 2009 5:13 PM

Technical Data

Jigsaw
Article number
Stroke rate control
Stroke rate preselection
Orbital action
Rated power input
Stroke rate at no load n
0
Stroke
Cutting capacity, max.
– in wood
– in aluminium
– in non-alloy steel
Bevel cuts (left/right), max.
Weight according to EPTA-Procedure 01/2003
Protection class
The values given are valid for nominal voltages [U] of 230/240 V. For lower voltage and models for specific countries,
these values can vary.
Please observe the article number on the type plate of your machine. The trade names of the individual machines
may vary.
Assembly
Before any work on the machine itself, pull
the mains plug.
Replacing/Inserting the Saw Blade
When mounting the saw blade, wear protec-
tive gloves. Danger of injury when touching
the saw blade.
Selecting a Saw Blade
An overview of recommended saw blades can
be found at the end of these instructions. Use
only T-shank saw blades. The saw blade should
not be longer than required for the intended cut.
Use a thin saw blade for narrow curve cuts.
Bosch Power Tools
GST 120 E
Professional
0 601 510 6..
W 650
-1
min 1500–2800
mm 26
mm 120
mm 20
mm 10
° 45
kg 2.6
/II
Inserting the Saw Blade (see figure A)
If required, remove the dust cover 14 (see "Dust
Cover").
Insert the saw blade 12 (teeth in cutting direc-
tion) into the stroke rod until it latches 10.
While inserting the saw blade, pay attention that
the back of the saw blade is positioned in the
groove of the guide roller 11.
10
11
English | 9
GST 120 BE
Professional
0 601 511 6..
–
650
500–2800
26
120
20
10
45
2.7
/II
1 609 929 S83 | (1.7.09)