Makita GS5000 Manuel D'instruction page 8

MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
1
2
013614
The tool and its air vents have to be kept clean.
Regularly clean the tool's air vents or whenever the
vents start to become obstructed.
Installing or removing dust cover (optional
accessory)
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the dust
cover attachments.
Failure to do so causes damage to the tool or a
•
personal injury.
Clean the dust cover attachments when the flow of
•
the air through the dust cover attachments
becomes obstructed with built up dust or foreign
matters. Continued operation in such a condition
may damage the tool.
When removing the dust cover attachments,
•
forcing it up without unhooking hook A or B may
break hooking part.
1
4
013619
Dust cover attachment R/L are respectively installed on
the handles R/L with the sides shown above facing
toward the tool.
1. Exhaust vent
2. Inhalation vent
1. Handle R
2. Dust cover
attachment R
3. Handle L
4. Dust cover
2
attachment L
3
2
1
3
1. Hook B
2. Hook A
3. Rib A
4. Vent A
5. vent B
013620
To install the attachments, insert hook A and rib A into
vent A lightly.
Insert hook B into vent B.
1
1. Dust cover attachment R
2. Dust cover attachment L
3. Screwdriver
013743
To remove, lift it up by using a slotted bit screwdriver
near the hook B.
Also lift it up near the hook A.
NOTE:
Dust cover attachments installed on GS5000 and
GS6000 do not cover the vents above and below the
brush holder which is designed dust-proof.
8
5
4
4
2
5
3
3
2
1