Safety Instructions - VOLTCRAFT DO-101 Notice D'emploi

5. Safety instructions

These instructions contain important information on how to use the device
correctly. Please read them carefully before using the device for the first time.
Damage caused due to failure to observe these instructions will void the war-
ranty. We shall not be liable for any consequential damage. We shall not be
liable for damage to property or personal injury caused by incorrect handling
or failure to observe the safety information! Such cases will void the warranty/
guarantee.
• This device was shipped in a safe condition.
• To ensure safe operation and to avoid damaging the device, always observe the
safety information and warnings in these instructions.
• The unauthorised conversion and/or modification of the device is not permitted for
safety and certification reasons.
• Consult an expert when in doubt about the operation, safety or connection of
the device.
• Meters and their accessories are not toys and must be kept out of the reach of
children.
• Always comply with the accident prevention regulations for electrical equipment
when using the product in commercial facilities.
• In schools, educational facilities, hobby and DIY workshops, meters must be used
under the responsible supervision of qualified personnel. The same applies when the
meter is used by people with reduced physical and mental capabilities.
• Do not use in the immediate vicinity of strong magnetic or electromagnetic fields,
transmitter aerials or RF generators. These may distort the measurements.
• If you suspect that safe operation is no longer possible, stop using the device
immediately and prevent unauthorised use. Safe operation can no longer be as-
sumed if:
- There are signs of damage
- The device does not function properly
- The device was stored under unfavourable conditions for a long period of time
- The device was subjected to rough handling during transport.
• Do not switch the device on immediately after it has been brought from a cold
room into a warm one. The condensation generated may destroy the product.
Leave the device disconnected and wait until it has reached room temperature.
28