Declaration Of Conformity; Noise/Vibration Information - Würth Master PM 250-E Notice D'utilisation

PM 250-E - .book Seite 15 Freitag, 22. September 2006 8:57 08
Warranty
For this Würth tool, we provide a warranty in
accordance with statutory /country-specific regula-
tions from the date of purchase (proof of purchase
by invoice or delivery note). Damage that has
occurred will be corrected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the warranty.
Claims can be recognised only when the tool is pre-
sented undisassembled to a Würth branch office or
a Würth field service employee.

Noise/Vibration Information

Sound emission:
Measured A-weighted sound power level L
(re 1 pW), in decibels: 96
Measuring uncertainty K , in decibels: 3
wA
A-weighted emission pressure power level measured
at the workplace L (re 20 µPa), in decibels: 85
pA
Measuring uncertainty K , in decibels: 3
pA
Vibration emission:
Rated acceleration, in m/s 2:
Measuring uncertainty K, in m/s
REMARK: The sum of the measured emission value
and respective measuring inaccuracy represents the
upper limit of the values that can occur during meas-
uring.
The maximum exposure values stipulated in the indus-
trial safety directives (e. g. in directive 2002/44/EC,
a maximum daily exposure limit of 5 m/s
a normal duration of 8 hours) must not be exceeded.
The value of the estimated weighted acceleration
obtained in the laboratory can serve for predicting
the exposure to vibration. During work, weighted
accelerations will be dependent on the particular
application, and deviation from this laboratory
value can occur.
Wear ear protection!
We declare under our sole responsibility that this
product is in conformity with the following standards
or
EN 60745-2-3,
EN 61000-3-2, EN 61000-3-3 according to the pro-
visions of the regulations 98/37/EC, 89/336/EEC.
Adolf Würth GmbH & Co. KG
P. Zürn
wA
2.1
2
: 1.5
2
relating to
Subject to change without notice

Declaration of Conformity

standardization documents:
EN 55014-1,
06
R. Bauer
EN 60745-1,
EN 55014-2,
15