Würth Master PM 250-E Notice D'utilisation page 12

PM 250-E - .book Seite 12 Freitag, 22. September 2006 8:57 08
Conduct the mains lead away from the rotat-
ing polishing accessory. If you lose control over
the power tool, the mains lead could be cut
through or caught, thereby drawing your hand
or your arm into the rotating polishing acces-
sory.
Never lay the power tool down until the pol-
ishing accessory has come to a complete stop.
The rotating polishing accessory could come
into contact with the underlying surface and
cause you to lose control over the power tool.
Do not carry the power tool at your side while
the motor is running. Accidental contact with
the rotating polishing accessory could cause it
to snag your clothing, pulling the accessory into
your body.
Causes of kick-back and precautionary meas-
ures for the operator.
– Kickback is a sudden reaction of the power tool
to a pinched or snagged polishing accessory,
sanding plate, brush or other accessory.
– Pinching or snagging causes a rapid stalling of
the rotating polishing accessory, which in turn
causes the uncontrolled power tool to be forced
in the direction opposite to the polishing acces-
sory's rotation at the point of the binding.
– The polishing accessory may either jump
towards or away from the operator, depending
on the direction of the wheel's rotation at the
point of pinching and can possible also break.
– Kickback is the result of power tool misuse and/
or incorrect operating procedures or conditions
and can be avoided by taking the proper pre-
cautions listed below.
Hold the power tool firmly and position your
body and arms optimally to withstand any
kickback forces. Always use the original aux-
iliary handle so that kickback forces or the
starting torque can be mastered in the best
possible way. The operator can master the
starting torque and kickback forces if suitable
precautionary measures are taken.
12
For Your Safety
Never place your hand near the rotating pol-
ishing accessory. The polishing accessory may
kick back over your hand.
Do not position your body in the area where
the power tool will move if kickback occurs.
Kickback will propel the power tool in the direc-
tion opposite to the polishing accessory's move-
ment at the point of snagging.
Take special care when machining corners,
sharp edges, etc. Prevent the polishing acces-
sory from bouncing off or tilting. Corners,
sharp edges or bouncing have a tendency to
snag the rotating polishing accessory and
cause loss of control or kickback.
Do not attach a saw chain, wood-carving
blade or circular saw blade. Blades of this kind
cause frequent kickback or loss of control over
the power tool.
Safety instructions, particularly for sanding work
with a sanding disc.
When sanding, do not use an excessively
oversized sanding disc. Follow the manufac-
turer's
sanding discs. Sanding discs larger than the
backing pad present a laceration hazard; they
can tear, cause snagging, rip off from the back-
ing pad or cause kickback.
Use only original Würth parts and accesso-
ries.
For further notes on safety refer to the enclosed sheet
recommendations when selecting