Whirlpool WED560LHW Guide D'utilisation Et D'entretien page 22

TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.whirlpool.com/owners
(in Canada www.whirlpool.ca/owners) for assistance and to possibly avoid a service call.
If you experience
Error Code Appears in Display (for 2- and 3-digit displays) (cont.)
"rL"
(remove load)
appears in display
F# E# or F## E## code
other than as described
above appears in display
Washer making error
beeps
Washer beeps when Start/
Pause is touched
Clean Washer LED flashing
at end of wash cycle
(on some models)
22
Possible Causes
Load detected in drum during Clean
Washer with affresh cycle.
®
System error code.
Door has not been opened and
closed for at least three cycles.
Door not closed.
The washer has run 30 wash cycles
and is indicating a reminder to run the
Clean Washer with affresh
®
Remove items from washer drum and restart Clean Washer
with affresh cycle.
®
Touch POWER once to clear the code. Then touch POWER
again to restart washer. If code appears again, call for service.
Unplug washer for 30 seconds; then plug back in.
This code may occur when the washer is first turned on.
Open and close the door to clear the display.
Close the door completely.
Run the Clean Washer with affresh
with affresh cycle is not turned on, the LED will stop flashing
®
cycle. at the end of a wash cycle after running three more regular
wash cycles. After 30 more wash cycles are completed, the
Clean Washer with affresh
a wash cycle as a reminder.
Solution
cycle. If the Clean Washer
®
LED will again flash at the end of
®