Notes Of Maintenance; Releasing The Transducer; Dimensional Drawings; Safety Notes - Camille Bauer SINEAX DME 401 Mode D'emploi

• Selection of the measured variables for up to 4 internal
counters
• Provision for resetting the maximum value detectors of
output and bus variables (RS 485 only)
• Provision for frequency measurement using either voltage
or current
• Defi nition of the measured variables on the bus to be up-
loaded via the MODBUS interface (RS 485) together with
the device address and the data transfer parameters.
Fig. 12. Bus parameters.
• Measurements displayed: All measured variables selected
on the transducer that has been addressed
• Power system check: Display of all the system values,
ideal as a wiring check (RS 232 only)
• Printing of nameplates.

8. Notes of maintenance

No maintenance is required.

9. Releasing the transducer

Release the transducer from a top-hat rail as shown in
Fig. 13.
Fig. 13
34

10. Dimensional drawings

15 16 17 18 19 20 21 22 23 24 25 26
1 2 3 4 5 6 7 8 9 11 13 14
87.5
Fig. 14. SINEAX DME in housing T24 clipped onto a top-hat rail
(35 ×15 mm or 35×7.5 mm, acc. to EN 50 022).
19
15 16 17 18 19 20 21 22 23 24 25 26
1 2 3 4 5 6 7 8 9 11 13 14
87.5
Fig. 15. SINEAX DME in housing T24 screw hole mounting
brackets pulled out.

11. Safety notes

● Before you start the device check for which power supply
it is built.
● Verify that the connection leads are in good condition and
that they are electrically dead while wiring the device.
● When it must be assumed that safe operation is no lon-
ger possible, take the device out of service (eventually
disconnect the power supply and the input voltage!).
This can be assumed on principle when the device shows
obvious signs of damage.
The device must only be used again after troubleshooting,
repair and a fi nal test of calibration and dielectric strength
in our factory or by one of our service facilities.
124
6.5
12
123.4