Adjustable Measuring Range; Commissioning And Maintenance; Releasing The Transducer; Instruments Admissions - Camille Bauer SINEAX I552 Mode D'emploi

Masquer les pouces Voir aussi pour SINEAX I552:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Symbol
Meaning
General symbol: Input
General symbol: Output
General symbol: Power supply
Measurement category CAT III for current and vol-
CAT III
tage inputs

6. Adjustable measuring range

Reliably isolate the measuring input from
dangerous voltages.
Setting:
Admissible alteration of full scale
output, variable sensitivity, adjust-
able with potentiometer P200.
Setting range:
0.85 - 1.15 · I
100%
10 11 12 13
+
4-20 mA
Fig. 7. Locations of the potentiometers P201 and P200.

7. Commissioning and maintenance

Switch on the power supply and the measuring input. It is
possible during the operation to disconnect the output line
and to connect a check instrument, e.g. for a functional test.
No maintenance is required.

8. Releasing the transducer

Release the transducer from a top-hat rail as shown in
Fig. 8.
Fig. 8
(± 15%)
N
I
N
0
0
Input
0.85
1
1.15
P201
P200
0,5

9. Instruments admissions

With maritime execution
(formerly GL, Germanischer Lloyd)
Type approval certificate: 12 258-98 HH
CSA approved for USA and Canada
file-nr. 204767
FCC Compliance and Canadian DOC Statement
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to both
part 15 of the FCC Rules and the radio interference regu-
lations of the Canadian Department of Communications:
These limits are designed to provide reasonable protec-
tion against harmful interference when the equipment is
operated in a commercial environment. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in
a residential area is like to cause harmful interference
in which case the user will be required to correct the
interference at his own expense.

10. Dimensional drawing

112.5
114.1
Fig. 9. Housing type P13/70 clipped onto a top-hat rail
(35 ×15 mm or 35×7.5 mm, acc. to EN 50 022).
10
11
12 13
1
2
3
4 5
6
7
8
9
70
11

Publicité

Chapitres

Table des Matières
loading

Table des Matières