EIBENSTOCK EBS 1802 SH Notice Originale page 20

Assembly
Lock the ON/OFF switch of the concrete grinder.
2
1
Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an
electric specialist.
Due to its design, the machine needs a minimum of care and maintenance.
However, the following points always have to be observed:
Always keep the power tool and the ventilation slots clean.
Put the top frame with the weights
2
on the frame handle of the machine.
Then put the device with the holder
under the frame handle and fix it with disc,
spring ring and wing nut
frame
3
Wind the line cord of the tool on the
holder meant for this purpose. Make
sure that the switch of the floor
guiding device is not pressed or
locked. Plug the grinder in the socket of
the floor guiding device. Lead the hose
of the vacuum cleaner above the floor
guiding device, connect it with the
grinder. The clamp will avoid a slipping
of the hose.
.
2
20
2
1
on the top
3