Fan Setting - Honeywell VisionPRO IAQ Mode D'emploi

Operating Manual

Fan setting

WED
FAN
70
Inside
AUTO
SYSTEM
HEAT
6:01
AM
SCHED HOLD CLOCK SCREEN
Press
70
Set To
Following
Schedule
MORE
F F A A N N
Press to select fan operation:
F F A A N N
• On: Fan is always on.
• Auto: Fan runs only when the heating
or cooling system is on.
• Circ: Fan runs randomly, about 35%
of the time. Use this setting for
improved air circulation, or for more
efficient air cleaning, if you do not
want the fan to run all the time.
You can press
F F A A N N
the fan settings you've programmed for
different time periods (see page 9). If you
select On or Circ, the setting you select
will remain active until you press
again to select Auto.
6
at any time to override
F F A A N N