Fan Setting - Honeywell VisionPRO TH8000 Serie Mode D'emploi

Fan setting

WED
FAN 70
Inside
AUTO
SYSTEM
HEAT
6:01
AM
SCHED HOLD CLOCK SCREEN
Press FAN
Note: If a fan schedule is programmed,
"Auto" will run the fan schedule.
70
Set To
Following
Schedule
MORE
Press FAN to select fan operation, then press
DONE.
• On: Fan is always on.
• Auto: Fan runs only when the heating or
cooling system is on.
• Circ: Fan runs randomly, about 35% of the
time, not counting any run time with the
heating or cooling system.
You can press FAN to override the fan settings
you've programmed for different time periods
(see page 11). If you select On or Circ, the set-
ting you select will remain active until you press
FAN again to select Auto (see page 31 for more
information).
7
VisionPRO TH8000 Series
®
69-2400EFS—05