Know Your Product; Led Indicator - Ryobi Rsi4 Mode D'emploi

ADDITIONAL BATTERY SAFETY
WARNINGS
To reduce the risk of fire, personal
injury, and product damage due to
a short circuit, never immerse the
tool, battery pack, or charger in fluid
or allow fluid to flow inside them.
Corrosive or
such as seawater, certain industrial
chemicals, and bleach or bleach-
containing products, etc., can cause
a short circuit.
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance
with local and national provisions and
regulations.
Follow all special
on packaging and
transporting batteries by a third party.
Ensure that no batteries can come
in contact with other batteries or
conductive materials while in transport
by protecting exposed connectors with
insulating, non-conductive
tape. Do not transport batteries that
are cracked or leaking. Check with the
forwarding company for further advice.

KNOW YOUR PRODUCT

See page 77.
1. Soldering tip cover
2. Cover tab

3. LED indicator

4. On/Off button
5. Battery cap
6. Cover tab slot
7. Battery pack
8. LED work light
9. Soldering pen tip
10. USB charging cable
11. Soldering reel
12. Operator's manual
13. USB power adaptor
4
conductive fluids,
requirements
labelling when
caps or
LED INDICATOR
Product status
Heating
Ready for use
Battery level
<25%
Low battery
No tip present
MAINTENANCE
The product
connected to
when assembling parts, making
adjustments, cleaning, performing
maintenance, or when the product
is not in use. Disconnecting the
product from the power supply will
prevent accidental
could cause serious injury.
When servicing, use only original
manufacturer's replacement parts,
accessories, and attachments. Use
of any other parts may create a
hazard or cause product damage.
Avoid using solvents when cleaning
plastic parts.
susceptible to
commercial solvents and may be
damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
Do not at any time let brake
fluids, gasoline, petroleum-based
products, penetrating
come in contact with plastic parts.
Chemicals can damage, weaken or
destroy plastic which may result in
serious personal injury.
For greater safety and reliability, all
repairs should be performed by an
authorised service centre.
LED light
Flashing green
Solid green (no
Solid red (no
Flashing red (3
Flashing green (3
should never be
a power source
starting that
Most plastics are
various types
oils, etc.,
of