i-tec CHARGER-C100W Mode D'emploi page 7

Les langues disponibles

CHARGER-C100W

SPECIFICATIONS

• Input voltage AC 100-240V, 50-60 Hz, max. 1.8A

• Output power (max): 100 W

• Eciency: more than 89 %

• USB-C output voltage: DC 5V / 9V / 12V / 15V / 20V

• USB-C output current: max. 5 A

• Protection against: current overload, overvoltage, short circuit and overheating.

• Operating values: 0°C - 30°C

• Relative humidity: 5% - 90%

• Product dimensions: 162 x 45 x 30 mm

• Product weight: 310g

USING THE POWER ADAPTER

Connecting the universal adapter to the device:

1. Connect the adapter to the 110/230V mains, using the supplied cable.

2. Connect the USB-C cable to the USB-C port of the product that you want to charge.

SAFETY INSTRUCTIONS FOR USING THE CHARGE HUB

General safety instructions

1. Follow these safety guidelines to prevent possible damage to your computer and

ensure your own safety. Unless o t h e rwi s e noted, all procedures in this doc-

ument assume that you have read the safety information that came with your

computer. Place the device on a hard, level surface. Leave approximately 10 cm of

clearance on all vented sides to allow air to flow for proper ventilation. Restricting

airflow may damage the equipment or cause a fire.

Do not stack the devices or place them so close together that they are exposed to

recirculation or preheated air.

Check that nothing is lying on the cables and that the cables are positioned so

that they cannot be tripped over or stepped on.

Make sure all cables are connected to the appropriate connectors. Some connec-

tors look similar and can be easily confused (for example, do not plug the phone

cable into the power connector).

5. Do not place the appliance in an enclosed wall unit or on a soft fabric surface such

as a bed, sofa or carpet.

6. Keep the equipment away from heat sources.

7. Keep the equipment away from extremely high or low temperatures so that it can

operate within its operating range.

8. Do not insert any objects into the vents or openings of the appliance. Failure to

do so may result in fire or electric shock due to short-circuiting of internal compo-

nents.

ENGLISH