Assembling The Stand - Ryobi Rts12 Manuel D'utilisation

ASSEMBLING THE STAND

See Figures 7 - 8.
NOTE: Do not use this leg stand with other equipment or
for other purposes.
„ Rest the inner leg assembly inside of the outer leg assem-
bly, so that the legs form an "X". Align holes for hardware.
„ Install leg stand bolts through holes and secure with hex
nuts. Tighten nuts securely.
„ Insert feet into the leg assemblies. Align holes for hard-
ware.
NOTE: The feet should point away from the assembly as
shown in figure 8.
„ Install foot bolts through holes and secure with hex nuts.
Tighten nuts securely.
MOUNTING THE TABLE SAW TO THE LEG
STAND
See Figures 9 - 11.
WARNING:
Do not lift the saw without help. The saw weighs approxi-
mately 55 lbs. Hold it close to your body. Keep your knees
bent and lift with your legs, not your back. Ignoring these
precautions can result in back injury.
„ With the unit in the upright position, spread the legs of
the stand. Place stand on level ground.
NOTE: When positioning the stand make sure each leg
is spread fully outward to ensure the stand's stability.
„ Position the table saw onto the stand so that the holes in
the saw's frame are aligned with the holes in the stand's
brackets.
NOTE: Make sure the table saw's frame is flush against the
stand and that all the stand legs are touching the ground.
Fig. 7
OUTER LEG
ASSEMBLY
LEG
STAND
BOLT
ASSEMBLY
INSIDE LEG
ASSEMBLY
HEX
NUT
Fig. 8
FOOT
BOLT
Fig. 9
Fig. 10
16 - English
HEX
NUT
WING
NUT
CARRIAGE
BOLTS