Volume; Sound Lights; Link Check; Lullabies - Alecto DBX-20 Mode D'emploi

Volume:

Pressing the and
the volume of the sound coming from the speaker. You have a choi-
ce of five volume levels and volume off. Two beep tones will sound
when the maximum volume has been reached.
The selected volume will be shown at the top of the display:

Sound Lights:

The parent unit comes with five audio lights. The louder the sound
that the baby unit picks up, the more the lights will show up on
C
the parent unit. In this way, you will know when the baby is crying,
even when the sound on the parent unit is switched off.

Link check:

Should the connection between the parent unit and the baby unit be broken, the
antenna symbol
usly.
The reason for this could be because the parent unit is out of range from the
baby unit or because the power of the baby monitor has run down.
Once the connection is restored, this symbol will stop flashing and the beep tones
will stop.

Lullabies:

Press the button on the parent unit to start playing lullabies on
the baby unit.
By default lullaby 1 will be played. Press the
playing the next lullaby. The dBX-20 has 5 lullabies.
The selected song is played continuously for 15 minutes.
The playback volume on the baby unit is fixed and cannot be changed.
Please note that you will be able hear the lullaby coming through the speaker of
the parent unit coming from the microphone of the baby unit. It is advisable to set
the volume of the parent unit off if you do not want to hear the lullaby.
buttons on the parent unit allows you to set
in the display will flash and a beep tone will sound continuo-
-29-
Bm11 Bm1120
button again to start
button
GB
C
C