Built-In Cd Player; Playing A Cd - Pioneer DEH-P8400MP Mode D'emploi

Built-in CD Player

Playing a CD

1
These are the basic steps necessary to play a
CD with your built-in CD player. More advanced
CD operation is explained starting on page 20.
1
indicator
TRACK NUMBER
Shows the track currently playing.
2
indicator
PLAY TIME
Shows the elapsed playing time of the cur-
rent track.
1 Press
EJECT.
CD loading slot appears.
2 Insert a CD into the CD loading slot.
Playback will automatically start.
CD loading slot
button
EJECT
• You can eject a CD by pressing
• If the front panel is in the EJECT position
(shown above), buttons other than
, , and
VOLUME OPEN ATT
trol) do not operate.
3 After a CD has been inserted, press
to select the built-in CD player.
SOURCE
Press until you see
SOURCE
played.
2
.
EJECT
EJECT,
(on the remote con-
dis-
Compact Disc
4 Use to adjust the sound level.
VOLUME
Rotate to increase or decrease the volume.
5 To perform fast forward or reverse, press
and hold 2 or 3 .
6 To skip back or forward to another track,
press 2 or 3 .
Pressing 3 skips to the start of the next track.
Pressing 2 once skips to the start of the current
track. Pressing again will skip to the previous
track.
Notes
• The built-in CD player plays one, standard,
12-cm or 8-cm (single) CD at a time. Do not
use an adapter when playing 8-cm CDs.
• Do not insert anything other than a CD into
the CD loading slot.
• If you cannot insert a disc completely or if
after you insert a disc the disc does not play,
check that the label side of the disc is up.
Press to eject the disc, and check the
EJECT
disc for damage before inserting the disc
again.
• 5 and ∞ can be operated when MP3 or WMA
is playing.
• If the built-in CD player does not operate prop-
erly, an error message such as
be displayed. Refer to Understanding built-in
CD player error messages on page 55.
Section
04
may
ERROR-11
En 19