Installation; Use - Vortice VORTDRY 1000 Notice D'emploi Et D'entretien

ENGLISH
• Specifications for the power supply must correspond
to the electrical data on ID plate A.
The appliance must be installed
•
by a qualified electrician.
Ensure that the electrical system
•
to which the
connected
applicable standards.
The appliance must be wired to
•
the power supply by way of a
Zone
3
10
appliance
complies with
Zone
2
multi-pole isolating switch with a
gap of at least 3 mm between
contacts.
The appliance is equipped with
•
IP24 protection for use in private
bathrooms in Zone 2.
Installation (fig. from 1 to 15)
The recommended installation measures, from the
base of the hair dryer to the floor are: 1.7 m for
men, 1.6 m for women and 1.4 for children (fig.1,
measure H).
The height of the appliance from the floor must
never be less than 140 cm.
1. Use the installation template, provided with the
product, to mark the 3 fixing points.(fig. 2)
2. Drill the wall in the 3 points marked with a 6 mm drill
(fig. 3A, cable insertion from the side; fig. 3B, cables
insertion from the back of the product) and insert the
anchor plugs flush with the wall.
3. Remove the hose locking screw (fig. 4a), turn the
tube clockwise and remove the tube with the handle
(fig. 4b).
is
4. Remove the screws on the lower cover (fig. 5)
5. Remove the front cover as shown in fig. 6.
6. Insert the connector (LINE and NEUTRAL cables)
from the back of the product into the appropriate
hole, located in the upper part of the backplate,
whether the connector comes from the back or from
Zone 1
Zone 0