Installation; Use - Vortice EASY DRY MANUAL Notice D'emploi Et D'entretien

ENGLISH
3mm between contacts.
• When installing the appliance in a public facility, wire a thermal cutout or residual current device in series with
the main switch.
• Should the appliance be dropped or suffer heavy impact, have it checked without delay by a Vortice
Technical Support Centre.
• Turn off the main isolating switch:
a) if the appliance does not function correctly;
b) before cleaning the outside of the appliance;
c) if the appliance is not going to be used for any length of time.
• If the appliance does not function correctly or develops a fault, contact a Vortice Technical Support Centre
without delay. Ensure that only genuine Vortice replacement parts are used for any repairs.
• Specifications for the power supply must correspond to the electrical data on ID plate A (Fig. 1).
The appliance must be installed by a qualified electrician.
•
The appliance must be wired to the power supply by way of a multi-
•
pole isolating switch with a gap of at least 3 mm between contacts.

Installation

Figure: 2 ÷ 12.
Easy Dry Manual
The circuit board mounted internally of the appliance is equipped with a potentiometer by means of which the
duration of the drying action can be adjusted from 1 minute (potentiometer rotated fully anticlockwise) up to 8
minutes (potentiometer rotated fully clockwise). (fig.11)
N.B. If the appliance is interlocked to a coin/token acceptor with an internal timer, the duration of the drying
action will be controlled by this same timer, which takes precedence over the potentiometer.
N.B. If the appliance is to be connected to a coin/token acceptor, the button on the front panel must be disabled
mechanically by the installer, using the screw provided.
See under "Use" for a more detailed description of operation with a coin/token acceptor.
Easy Dry Auto
The circuit board mounted internally of the appliance is equipped with a trimmer by means of which the
sensitivity of the optical sensors can be adjusted. (fig.11)

Use

Figures: 13,14.
N.B. In the event of the appliance overheating, a thermal overload cutout will be tripped to protect the heating
element. This device resets automatically. Should the thermal overload cutout fail to operate, a second safety
device will automatically disconnect the heating element from the power supply.
N.B. A built-in anti-vandal device will disconnect the appliance from the power supply after approximately 20
minutes continuous operation. The device resets automatically once the problem has been rectified.
Easy Dry Manual
The appliance can be activated by one of two methods:
-- pressing the button on the front panel
--control signal from an external coin/token acceptor: the appliance can be connected to an external coin or
token acceptor, and will be activated when a coin or token is inserted in the slot;
if the coin/token acceptor has an internal timer, this will determine the duration of the drying action; if not, the
duration will be determined by the timer built into the appliance.
Easy Dry Auto
A time-out function set at approximately 15 seconds allows the user to move away momentarily from the
appliance without tripping the automatic shutoff.