Mounting The Bath Cover (Accessories)); Bath Fluid - Julabo PURA 4 Mode D'emploi

Preparations

20.2 Mounting the bath cover (accessories))

20.3 Bath fluid

The bath cover is mounted with two hinges. The left side is shown.
5. Loosen the screws on the side of the device housing. Do
not unscrew screws.
6. Push the hinges of the bath cover with the oblong holes
over the screws.
7. Slide the hinges on the screws down to the stop.
8. Tighten the screws.
The bath cover is mounted.
Risk of corrosion in the bath due to non-approved bath
fluid!
Unsuitable, non-approved bath fluids can damage the water bath.
Only water is permitted as a bath fluid.

JULABO recommends a water mixture of 70% softened/descaled

water and 30% tap water.
Consult JULABO before using a bath fluid other than the

recommended one.
41