Important - Weiser Elements Ged1400 Guide D'installation Et D'utilisation

5
Install interior assembly
A
Remove the battery cover.
J
D
Align the colored edges of the connectors
and ensure a tight cable connection.
G
Test the turnpiece for smooth rotation.
If turnpiece
doesn't rotate,
repeat steps 5E
and 5F, making
sure to rotate
the turnpiece
AWAY from the
door edge.
6
Set locking and unlocking direction
A
To activate the screen, touch screen with
palm or back of hand until digits illuminate.
D
If successful, activate the screen.
Press the Lock symbol. The latch bolt will extend to lock.
= Lock symbol
During normal
operation, press the
Lock symbol to lock
the door.
B
Load 4 AA batteries into the interior
assembly. For best results, use new, non-
rechargeable Alkaline batteries only.
Note: Turnpiece
H
may move
on its own.
E
IMPORTANT: Rotate the turnpiece AWAY
from the door edge and make sure the latch
is fully retracted (in the unlocked position).
45°
H
Secure the interior assembly with
the supplied screws.
B
While the door is OPEN and UNLOCKED, activate the screen.
Enter the following code to teach
the lock the orientation of the door:
This is your default
Programming Code.
1. Press 0-0-0-0.
2. Press . You will hear one beep.
3. Press 0.
4. Press .
E
Activate the screen. Touch the random digits that appear (this is a security feature
that ensures fingerprints are spread around the entire screen).
Enter the default User Code (1-2-3-4), then press the Lock symbol. The door will unlock.
H
Ensure correct
polarity.
unlocked
door
edge
L (3x)
Touch random Enter User Code.
digits. Default: 1-2-3-4
IMPORTANT: It is recommended that you replace the default
Programming Code and default User Code with codes of your own. See page 4.
3 / 4
C
Press and hold the Reset button on the interior
assembly for 5 seconds, until you hear 3 long beeps.
F
Make sure the torque blade is still in the horizontal
position and install the interior assembly.
horizontal
I
Reinstall battery cover and make sure the
latch is still in the unlocked position.
J
C
The latch bolt will extend and retract.
If successful, you will hear 2 beeps.
If unsuccessful, you will hear 3 beeps. If
batteries are low, you will hear 10 beeps.
If unsuccessful,
make sure the door
is unlocked and that
you are using a fresh
set of batteries.
Press Lock symbol.
your user code to
unlocked
During normal
operation, press
the Lock symbol
after entering
unlock the door.