Display Backlight; Messages; Recycling Instruction - Dini Argeo NWL Série Manuel D'utilisation

6.6 DISPLAY BACKLIGHT

By keeping pressed the ZERO-B.L key, the display will scroll the possible activation modes; release the key when
the desired functioning is displayed:
OFF backlighting always off.
ON backlighting always on.
AUTO backlighting on when the weight is unstable or when a key is pressed. The backlighting remains active for 5
seconds.

7. MESSAGES

MESSAGES DESCRIPTION
- - OF - - Over range
Err 2 / ZERO Zero Error
UNSTA Auto Zero Error
- - ADC - - Input signal
overflow error
- LO - Accumulator
voltage low
- SYS - Calibration error
- - AC - - Accumulator
recharge.
Err - Lo Alarm setting wrong Please reset the alarm value.
The crossed-out wheeled bin on the product means that at the product end of life, it
must be taken to separate collection or to the reseller when a new equivalent type of
equipment is purchased. The adequate differentiated refuse collection in having the
product recycled, helps to avoid possible negative effects on the environment and
health and supports the recycling of the materials of which the equipment is made.
The unlawful disposal of the product by the user will entail fines foreseen by the
current regulations.
RESOLUTION
Remove weight from the scale.
Upon start-up or when the ZERO key is pressed, the weight on the
scale exceeds the +/- 10% of the max. capacity.
Remove the excess weight and retry.
Upon start-up, the weight on the scale is not stable to be zeroed. It
maybe because of the platform's intensity is too low or the platform is
shaken strongly.
You may strengthen the platform or avoid the shake.
Indicates that the A/D converter value is overflows:
- Remove the weight from the scale if it's exceeding.
- The load cell or the electronics could be damaged.
One can use the scale in a short time, but you should plug in the AC
plug as soon as possible to recharge the accumulator.
Please re-calibrate the scale with the procedure with zero acquisition
(see section 6.4). If the problem persists contact the dealer.

RECYCLING INSTRUCTION

11