Adjusting The Sound; Listening To The Sound - Sony HT-K215 Mode D'emploi

Table des Matières

Les langues disponibles

Notes

• The front balance, rear balance, center level, and rear level are

shown in the display during adjustment.

• Although these adjustments can also be made via the front

panel using the LEVEL menu (when the test tone is output, the

amplifier switches to the LEVEL menu automatically), we

recommend you follow the procedure described above and

adjust the speaker levels from your listening position using the

remote control.

When setting the volume levels for each speaker

Let's assume that you have matched the sound levels of all the

speakers using the test tone. Although this lays the foundation

for high quality surround sound, it may be necessary to make

further adjustments while listening to playback of actual

software. This is because most software contains center and rear

channels recorded at slightly lower levels than the two front

channels.

When you actually play back software recorded in multi channel

surround, you will notice that increasing the center and rear

speaker levels produces a better blend between the front and

center speakers and greater cohesion between the front and rear

speakers. Increasing the level of the center speaker about 1 dB,

and the rear speakers about 1~2 dB is likely to produce better

results.

In other words, in order to create a more cohesive soundstage

with balanced dialog, we recommend that you make some

adjustments while playing your software. Changes of only 1 dB

can make a huge difference in the character of the soundstage.

Listening to the sound

POWER

POWER indicator

First, turn down the volume on the amplifier. The volume

should be set to minimum before you begin playing the

programme source.

Turn on the amplifier and select the programme

source.

Press POWER on the subwoofer.

The POWER indicator on the subwoofer lights up in

green.

Play the programme source.

LEVEL

MIN

MAX