Applications; Charging Method - Hitachi UC 24YJ Instructions De Sécurité Et Mode D'emploi

English
SPECIFICATIONS
Input power source
Charging voltage
Charging current
Weight

APPLICATIONS

For charging the HITACHI batteries types EB7, EB9, EB12, EB14, EB18 and EB24 series.

CHARGING METHOD

NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
1. Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted into the receptacle, charge status
lamp will blink in red. (At 1-second intervals)
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown in Fig. 2. Make sure it contacts the
bottom of the battery charger.
8
Single phase: AC 120 V 60 Hz
DC 7.2 – 24 V
DC 9A ........................................... 7.2 – 14.4 V batteries
DC 7.5A ........................................ 18 V batteries
DC 6A ........................................... 24 V battery
2.2 lbs (1.0 kg)
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
WARNING:
Do not use the electrical cord if damaged. Have it
repaired immediately.