Modifying The Schedule - Honeywell PRO 2000 Série Mode D'emploi

Operating Manual

Modifying the schedule

Press the Set button 3 times until Set Schedule appears. The start time of
the first period (Wake) of the week days (Mon-Fri) will flash.
Press the or
Press the Set button. The temperature setting for that period will flash.
To program the temperature settings for the cooling mode, place the
System switch in Cool. To program the temperature settings for the
heating mode, place the switch in Heat.
Press the or
Press the Set button. The start time of the next period will flash.
Repeat steps 2 through 6 for each of the remaining periods.
Once all adjustments are made, press the Run button to save them and
exit. (The changes are also saved if you do not press any button for 60 seconds.)
button to set the time.
button to set the temperature.
10
The Wake
period for the
weekdays is
set to 6 a.m.
and 70 °F
(Heating
mode).
To skip a
period (except
Wake), press
the Hold
button for 4
sec. while that
period is
displayed.