Operating The Appliance; Button(S) Description - VINCENT SV-232 Manuel D'utilisation

Operation
Switch on and off
Individually activate or
deactivate speaker
outputs A and B
Select an input
Change the volume
Mute the speakers and
the preamplifier output
Vincent
38

OPERATING THE APPLIANCE

Button(s) Description

The amplifier is switched on and off using this button at the front panel.
When switched off the device is not internally separated from the AC
power and reacts to a signal at the input "POWER CONTROL INPUT"
POWER (6)
(15). That is why it is not possible to switch off the amplifier as long as a
12V trigger signal is present at this input. As a precaution, after switching
on, the volume setting should be reduced.
To play back stero music via loudspeakers at least one pair of them must be
attached to the amplifier (a practical choice would be connectors "A"). The
SPEAKER
output you use must be activated using the corresponding button "SPEA-
A/B (1)
KER" (LED illuminated). Only if a second pair of speakers is used, it is
necessary to activate the second speaker output "B".
A short touch on the button for the desired input channel
("LINE1"..."LINE6") changes to the playback of the audio source connec-
Input
ted there. The front panel as well as the remote control carry those buttons.
Selector
The name of the currently selected input channel appears in the display.
buttons
Before switching over the input channel, the volume (4)(19) should be tur-
(5)(22)
ned down as a precaution!
Hold down the button "LEVEL
Use "LEVEL
LEVEL /
(4) current volume value. The minimum volume value is -99dB, the maximum
volume appears at latest with 00dB, for most speakers much below this
VOLUME value. The volume value can not be changed if the input "LINE6" has been
selected. In this case the display shows "MAX". The volume setting does not
/ (19)
influence the signal at the output "OUTPUT REC" (11).
The MUTE function can only be operated with the remote control. It swit-
ches off the loudspeakers (14), the preamplifier output "OUTPUT PRE" (13)
and the recording output "OUTPUT REC" (11). Pressing it again restores the
MUTE (17)
volume to its original setting. As long as the amplifier is muted, the display
shows "MUTING".
" or "VOLUME
" or "VOLUME " to turn it down. The display (2) shows the
" to turn the volume up.